R3303-HP HSR6800 Routers Layer 2 - WAN Configuration Guide

[Router-isp-system] ip pool 1 1.1.1.2 1.1.1.10

2. Configure MS-CHAP authentication:

# Add a PPPoE user.

<Router> system-view

[Router] local-user user1

[Router-luser-user1] password simple pass1

[Router-luser-user1] service-type ppp

[Router-luser-user1] quit

# Configure virtual-template 1 on the Router.

[Router] interface virtual-template 1

[Router-Virtual-Template1] ppp authentication-mode ms-chap domain system

[Router-Virtual-Template1] remote address pool 1

[Router-Virtual-Template1] ip address 1.1.1.1 255.0.0.0

[Router-Virtual-Template1] quit

# Configure the PPPoE server on the Router.

[Router] interface gigabitethernet 1/0/1

[Router-GigabitEthernet1/0/1] pppoe-server bind virtual-template 1

[Router-GigabitEthernet1/0/1] quit

# Configure local authentication for the users in the default ISP domain system.

[Router] domain system

[Router-isp-system] authentication ppp local

# Add a local IP address pool that contains nine IP addresses.

[Router-isp-system] ip pool 1 1.1.1.2 1.1.1.10

Verifying the configuration

After the configuration, Host A and Host B can access the Internet using the username user1 and

password pass1 through the Router if they have PPPoE client software installed.

If you specify the authentication scheme as radius-scheme or hwtacacs-scheme by using the

authentication ppp command, you must configure RADIUS/HWTACACS settings to enable AAA. For

more information, see Security Configuration Guide.