R3303-HP HSR6800 Routers Security Command Reference

337
Syntax
local { multi-subnet | single-subnet }
undo local
Default
The subnet is a single one.
Views
IKE peer view
Default command level
2: System level
Parameters
multi-subnet: Sets the subnet type to multiple.
single-subnet: Sets the subnet type to single.
Usage guidelines
Use this command to enable interoperability with a NetScreen device.
Examples
# Set the subnet type of the local security gateway to multiple.
<Sysname> system-view
[Sysname] ike peer xhy
[Sysname-ike-peer-xhy] local multi-subnet
local-address
Use local-address to configure the IP address of the local security gateway in IKE negotiation.
Use undo local-address to remove the configuration.
Syntax
local-address [ ipv6 ] ip-address
undo local-address
Default
The primary address of the interface referencing the IPsec policy is used as the local security gateway IP
address for IKE negotiation. Use this command if you want to specify a different address for the local
security gateway.
Views
IKE peer view
Default command level
2: System level
Parameters
ipv6: Specifies an IPv6 address.
ip-address: Specifies the IP address of the local security gateway to be used in IKE negotiation.