R3303-HP HSR6800 Routers Security Command Reference

341
undo proposal [ proposal-number ]
Default
An IKE peer references no IKE proposals and, when initiating IKE negotiation, it uses the IKE proposals
configured in system view.
Views
IKE peer view
Default command level
2: System level
Parameters
proposal-number&<1-6>: Specifies the sequence number of the IKE proposal for the IKE peer to
reference, in the range of 1 to 65535. &<1-6> means that you can specify the proposal-number
argument for up to six times. An IKE proposal with a smaller sequence number has a higher priority.
Usage guidelines
In the IKE negotiation phase 1, the local end uses the IKE proposals specified for it, if any.
An IKE peer can reference up to six IKE proposals.
The responder uses the IKE proposals configured in system view for negotiation.
Examples
# Configure IKE peer peer1 to reference IKE proposal 10.
<Sysname> system-view
[Sysname] ike peer peer1
[Sysname-ike-peer-peer1] proposal 10
Related commands
• ike proposal
• ike peer (system view)
remote-address
Use remote-address to configure the IP address of the IPsec remote security gateway.
Use undo remote-address to remove the configuration.
Syntax
remote-address [ ipv6 ] { hostname [ dynamic ] | low-ip-address [ high-ip-address ] }
undo remote-address
Views
IKE peer view
Default command level
2: System level
Parameters
ipv6: Specifies an IPv6 address.