R3303-HP HSR6800 Routers Security Configuration Guide

157
3. Configure direct portal authentication on interface GigabitEthernet 3/0/2, which is directly
connected with the host.
4. Configure the portal server detection function on the access device, so that the access device can
detect the status of the portal server by cooperating with the portal server heartbeat function.
5. Configure the portal user information synchronization function, so that the access device can
synchronize portal user information with the portal server by cooperating with the portal user
heartbeat function.
Configuration prerequisites
• Configure IP addresses for the host, router, and servers as shown in Figure 61 and make sure they
can reach each other.
• Configure the RADIUS server properly to provide authentication and authorization functions for
users.
Configuring the portal server
This example assumes that the portal server runs on IMC PLAT 5.1 SP1 (E0202P05) and IMC UAM 5.1
(E0301).
1. Configure the portal server:
a. Log in to the IMC management platform and select the Service tab.
b. Select User Access Manager > Portal Service > Server from the navigation tree to enter the
portal server configuration page, as shown in Figure 62.
c. Configu
re the portal server heartbeat interval and user heartbeat interval.
d. Use default values for other parameters.
e. Click OK.
Figure 62 Portal server configuration
2. Configure the IP address group:
a. Select User Access Manager > Portal Service > IP Group from the navigation tree to enter the
portal IP address group configuration page.
b. Click Add to enter the page shown in Figure 63.