R3303-HP HSR6800 Routers Security Configuration Guide

158
c. Enter the IP group name.
d. Enter the start IP address and end IP address of the IP group.
Make sure that the host IP address is in the IP group.
e. Select a service group.
By default, the group Ungrouped is used.
f. Select the IP group type Normal.
g. Click OK.
Figure 63 Adding an IP address group
3. Add a portal device:
a. Select User Access Manager > Portal Service > Device from the navigation tree to enter the
portal device configuration page.
b. Click Add to enter the page shown in Figure 64.
c. Enter the device name NA
S.
d. Enter the IP address of the router's interface connected to the user.
e. Enter the key, which must be the same as that configured on the switch.
f. Set whether to enable IP address reallocation.
This example uses direct portal authentication, and therefore select No from the Reallocate IP
list.
g. Select Yes for both Support Server Heartbeat and Support User Heartbeat.
h. Click OK.
Figure 64 Adding a portal device