R3303-HP HSR6800 Routers Security Configuration Guide

160
[Router-radius-rs1] user-name-format without-domain
[Router-radius-rs1] quit
2. Configure an authentication domain:
# Create ISP domain dm1 and enter its view.
[Router] domain dm1
# Configure AAA methods for the ISP domain.
[Router-isp-dm1] authentication portal radius-scheme rs1
[Router-isp-dm1] authorization portal radius-scheme rs1
[Router-isp-dm1] quit
# Configure domain dm1 as the default ISP domain for all users. Then, if a user enters a username
without any ISP domain at logon, the authentication/authorization methods of the default domain
are used for the user.
[Router] domain default enable dm1
3. Configure portal authentication:
# Configure a portal server on the router, specifying the portal server name as newpt, IP address
as 192.168.0.111, key as plaintext string portal, port number as 50100, and URL as
http://192.168.0.111:8080/portal.
[Router] portal server newpt ip 192.168.0.111 key simple portal port 50100 url
http://192.168.0.111:8080/portal
# Enable portal authentication on the interface connecting the host.
[Router] interface gigabitethernet 3/0/2
[Router–GigabitEthernet3/0/2] portal server newpt method direct
[Router–GigabitEthernet3/0/2] quit
4. Configure the portal server detection function:
# Configure the access device to detect portal server newpt, specifying the detection method as
portal heartbeat probe, setting the server probe interval to 40 seconds, and specifying the access
device to send a server unreachable trap message and disable portal authentication to permit
unauthenticated portal users if two consecutive probes fail.
[Router] portal server newpt server-detect method portal-heartbeat action trap
permit-all interval 40 retry 2
The product of interval and retry must be greater than or equal to the portal server heartbeat
interval, and HP recommends configuring the interval to be greater than the portal server
heartbeat interval configured on the portal server.
5. Configure portal user information synchronization:
# Configure the access device to synchronize portal user information with portal server newpt,
setting the synchronization probe interval to 600 seconds, and specifying the access device to log
off users if the users do not appear in the user synchronization packets sent from the server within
two consecutive probe intervals.
[Router] portal server newpt user-sync interval 600 retry 2
The product of interval and retry must be greater than or equal to the portal user heartbeat interval,
and HP recommends configuring the interval to be greater than the portal user heartbeat interval
configured on the portal server.
Verifying the configuration
Use the following command to view information about the portal server.
<Router> display portal server newpt
Portal server: