R3303-HP HSR6800 Routers Security Configuration Guide

281
# Assign an IPv6 address to each interface. (Details not shown.)
# Create a RIPng process and enable it on GigabitEthernet 3/0/1.
<RouterC> system-view
[RouterC] ripng 1
[RouterC-ripng-1] quit
[RouterC] interface gigabitethernet 3/0/1
[RouterC-GigabitEthernet3/0/1] ripng 1 enable
[RouterC-GigabitEthernet3/0/1] quit
# Create an IPsec transform set named tran1, and set the encapsulation mode to transport mode,
the security protocol to ESP, the encryption algorithm to DES, and authentication algorithm to
SHA1-HMAC-96.
[RouterC] ipsec transform-set tran1
[RouterC-ipsec-transform-set-tran1] encapsulation-mode transport
[RouterC-ipsec-transform-set-tran1] transform esp
[RouterC-ipsec-transform-set-tran1] esp encryption-algorithm des
[RouterC-ipsec-transform-set-tran1] esp authentication-algorithm sha1
[RouterC-ipsec-transform-set-tran1] quit
# Create an IPsec policy named policy001, specify the manual mode for it, and configure the SPIs
of the inbound and outbound SAs as 123456, and the keys for the inbound and outbound SAs
using ESP as abcdefg.
[RouterC] ipsec policy policy001 10 manual
[RouterC-ipsec-policy-manual-policy001-10] transform-set tran1
[RouterC-ipsec-policy-manual-policy001-10] sa spi outbound esp 123456
[RouterC-ipsec-policy-manual-policy001-10] sa spi inbound esp 123456
[RouterC-ipsec-policy-manual-policy001-10] sa string-key outbound esp abcdefg
[RouterC-ipsec-policy-manual-policy001-10] sa string-key inbound esp abcdefg
[RouterC-ipsec-policy-manual-policy001-10] quit
# Apply IPsec policy policy001 to the RIPng process.
[RouterC] ripng 1
[RouterC-ripng-1] enable ipsec-policy policy001
[RouterC-ripng-1] quit
4. Verify the configuration:
After the configuration, Router A, Router B, and Router C learn IPv6 routing information through
RIPng. SAs are set up successfully, and the IPsec tunnel between two peers is up for protecting the
RIPng packets.
# Execute the display ripng command on Router A to view the running status and configuration
information of the specified RIPng process.
<RouterA> display ripng 1
Public vpn-instance name :
RIPng process : 1
Preference : 100
Checkzero : Enabled
Default Cost : 0
Maximum number of balanced paths : 8
Update time : 30 sec(s) Timeout time : 180 sec(s)
Suppress time : 120 sec(s) Garbage-Collect time : 120 sec(s)
Number of periodic updates sent : 186