R3303-HP HSR6800 Routers Security Configuration Guide

291
• Specify the IKE proposals for the local end to use when acting as the IKE negotiation initiator. When
acting as the responder, the local end uses the IKE proposals configured in system view for
negotiation.
• Configure a pre-shared key for pre-shared key authentication or a PKI domain for digital signature
authentication.
• Specify the ID type for the local end to use in IKE negotiation phase 1. With pre-shared key
authentication, the ID type must be IP address for main mode IKE negotiation and can be IP address,
FQDN, or user FQDN for aggressive mode IKE negotiation.
• Specify the name or IP address of the local security gateway. You perform this task only when you
want to specify a special address, a loopback interface address, for example, as the local security
gateway address.
• Specify the name or IP address of the remote security gateway. For the local end to initiate IKE
negotiation, you must specify the name or IP address of the remote security gateway on the local
end so the local end can find the remote end.
• Enable NAT traversal. If there is NAT gateway on the path for tunneling, you must configure NAT
traversal at the two ends of the IPsec tunnel, because one end might use a public address while the
other end uses a private address.
• Specify the DPD detector for the IKE peer.
To configure an IKE peer:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an IKE peer and
enter IKE peer view.
ike peer peer-name N/A
3. Specify the IKE negotiation
mode for phase 1.
exchange-mode { aggressive | main }
Optional.
The default is main.
In FIPS mode, the aggressive
mode is not supported.
4. Specify the IKE proposals for
the IKE peer to reference.
proposal proposal-number&<1-6>
Optional.
By default, an IKE peer references
no IKE proposals, and, when
initiating IKE negotiation, it uses
the IKE proposals configured in
system view.
5. Configure a pre-shared key
for pre-shared key
authentication or specify a
PKI domain for digital
signature authentication.
• To configure a pre-shared key:
pre-shared-key [ cipher | simple ]
key
• To specify a PKI domain:
certificate domain domain-name
Configure either command
according to the authentication
method for the IKE proposal.
In FIPS mode, the pre-shared key
must contain at least eight
characters comprising digits,
uppercase and lowercase letters,
and special characters.
6. Select the ID type for IKE
negotiation phase 1.
id-type { ip | name | user-fqdn }
Optional.
By default, the ID type is IP.