R3303-HP HSR6800 Routers Security Configuration Guide

317
Task Remarks
Working with SFTP files Optional.
Displaying help information Optional.
Terminating the connection with the SFTP server Optional.
Specifying a source IP address or source interface for the SFTP
client
By default, an SFTP client uses the IP address of the outbound interface specified by the route to the SFTP
server as the source IP address to communicate with the SFTP server. You can change the source IP
address or specify a source interface for the client.
To make sure the SFTP client and the SFTP server can communicate with each other, and to improve the
manageability of SFTP clients in the authentication service, HP recommends that you specify a loopback
interface as the source interface.
To specify a source IP address or interface for the SFTP client:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Specify a source IP
address or interface for
the SFTP client.
• Specify a source IPv4 address or interface
for the SFTP client:
sftp client source { interface interface-type
interface-number | ip ip-address }
• Specify a source IPv6 address or interface
for the SFTP client:
sftp client ipv6 source { interface
interface-type interface-number | ipv6
ipv6-address }
Use either command.
Establishing a connection to an SFTP server
You can launch the SFTP client to establish a connection to an SFTP server, and specify the public key
algorithm, the preferred encryption algorithm, preferred HMAC algorithm, and preferred key exchange
algorithm.
After the connection is established, you can directly enter SFTP client view on the server to perform
directory and file operations.
To establish a connection to an SFTP server: