R3303-HP HSR6800 Routers Security Configuration Guide

30
Ste
p
Command Remarks
3. Specify a shared key for
secure RADIUS
authentication/authorization
or accounting
communication.
key { accounting | authentication }
[ cipher | simple ] key
By default, no shared key is
specified.
In FIPS mode, the shared key must
be a string of at least 8 characters
that contain numbers, uppercase
letters, lowercase letters, and
special characters.
The shared key configured on the
device must be the same as that
configured on the RADIUS server.
Specifying a VPN for the RADIUS scheme
You can specify a VPN for all the AAA servers in a RADIUS scheme. However, the VPN has a lower
priority than those configured for individual RADIUS servers.
To specify a VPN for a RADIUS scheme:
Ste
p
Command
1. Enter system view.
system-view
2. Enter RADIUS scheme view.
radius scheme radius-scheme-name
3. Specify a VPN for the RADIUS scheme.
vpn-instance vpn-instance-name
Setting the username format and traffic statistics units
A username is usually in the format userid@isp-name, where isp-name represents the user's ISP domain
name. By default, the ISP domain name is included in a username; however, some earlier RADIUS
servers do not recognize usernames that contain the ISP domain names. In this case, you can configure
the device to remove the domain name from each username to be sent.
The device periodically sends accounting updates to RADIUS accounting servers to report the traffic
statistics of online users. For normal and accurate traffic statistics, make sure that the unit for data flows
and that for packets on the device are consistent with those on the RADIUS server.
To set the username format and the traffic statistics units for a RADIUS scheme:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RADIUS scheme view.
radius scheme radius-scheme-name
N/A
3. Set the format for usernames
sent to the RADIUS servers.
user-name-format { keep-original |
with-domain | without-domain }
Optional.
By default, the ISP domain name
is included in a username.
4. Specify the unit for data flows
or packets sent to the RADIUS
servers.
data-flow-format { data { byte |
giga-byte | kilo-byte | mega-byte }
| packet { giga-packet | kilo-packet
| mega-packet | one-packet } }*
Optional.
The default unit is byte for data
flows and one-packet for data
packets.