R3303-HP HSR6800 Routers Security Configuration Guide

65
b. Click Add to configure an access device as follows:
Set the shared key for secure authentication communication to expert.
Set the ports for authentication to 1812, respectively.
Select the service type LAN Access Service.
Select the access device type HP(General).
Select the access device from the device list or manually add the device with the IP address
10.1.1.2.
c. Leave the default settings for other parameters and click OK.
The IP address of the access device specified here must be the same as the source IP address of the
RADIUS packets sent from the router, which is chosen in the following order on the router:
{ IP address specified with the nas-ip command.
{ IP address specified with the radius nas-ip command.
{ IP address of the outbound interface (the default).
Figure 19 Adding the router as an access device
2. Add a service:
a. Click the Service tab, and then select User Access Manager > Service Configuration from the
navigation tree.
b. Click Add to configure a service as follows:
Enter Portal auth as the service name.
Enter dm1 as the service suffix to represent the authentication domain for the portal user. With
the service suffix configured, you must configure the access device to send usernames that
carry domain names to the RADIUS server.
Configure other parameters as needed.
c. Click OK.