R3303-HP HSR6800 Routers Security Configuration Guide

66
Figure 20 Adding a service
3. Add an access user account:
a. Click the User tab, and then select Access User View > All Access Users from the navigation
tree.
b. Click Add to configure a user as follows:
Select the user or add a user named hello.
Enter the account name portal and specify the password.
Select the access service Portal auth.
Configure other parameters as needed.
c. Click OK.
Figure 21 Adding an access user account
Configuring the portal server
This section assumes that the RADIUS server runs on IMC PLAT 5.1 SP1 (E0202P05) and IMC UAM 5.1
(E0301).
1. Configure the portal server:
a. Log in to IMC, click the Service tab, and then select User Access Manager > Portal Service >
Server from the navigation tree.
b. Enter the URL address of the portal authentication main page, in the format
http://ip:port/portal, where ip and port are those configured during IMC UAM installation.
Usually, the default port 8080 is used.
c. Leave the default settings for other parameters and click OK.