Ignite-UX Administration Guide for HP-UX 11i (B3921-90079, October 2013)

Figure 78 Network Interface(s) Dialog Box
1. Select an Interface card from the selection list.
2. Select DHCP Managed if you want the selected interface configured using information obtained
via DHCP. When this is selected, the IP Address and Subnet Mask fields are not shown.
3. Enter or modify the IP Address: as needed; this is not required with DHCP Managed.
4. Enter or modify the Subnet Mask: as needed; this is not required with DHCP Managed.
5. Select Primary Interface, depending on the status you want for the selected interface. If the
client has more than one interface, the Primary Interface will be associated with the hostname
of the system in /etc/hosts.
6. Click Modify when you have finished updating each interface.
Security Choices...
Click this button on the System tab to invoke the Security Choices dialog box. This button is available
only if you have install-time security available in your configuration. The install-time security choices
allow you to choose from several predefined security levels, thereby hardening the system. If you
select a security choice, be sure to set the root password before you click Go!, or your system may
be vulnerable.
Figure 79 Security Choices Dialog Box
File System Tab
The File System tab enables you to do a variety of file system and disk configuration tasks. Its
appearance depends on your file system selection on the Basic tab. The example in Figure 80
illustrates what you would see if you had selected LVM on a PA-RISC client.
Configuring the Installation 137