Ignite-UX Administration Guide for HP-UX 11i (B3921-90079, October 2013)

# Performing task "Add Remote Printer": Adding "remoteprinter"
#
/usr/sbin/lpadmin -premoteprinter -ormserver.com -orptsslj \
-mrmodel -v/dev/null -orc -ocmrcmodel -osmrsmodel
/usr/sbin/lpadmin -dremoteprinter
/usr/sbin/accept remoteprinter
/usr/bin/enable remoteprinter
NOTE: Make sure that the directory the post-installation script resides in is available to tftp by
examining and changing the /etc/inetd.conf file.
1. Create a script to set up access to a default network printer.
2. Ignite-UX post-installation scripts are defined using the post_config_script variable. To
add the script you created in the previous step, edit your core_cfg configuration file and
add the following line:
post_config_script += \
"/var/opt/ignite/scripts/install_default_printer"
IMPORTANT: You must ensure that the variable _hp_cfg_detail_level value includes
t when a post_config_script is added in the Per-Client configuration file. For more
information, see the instl_adm(4).
For example, the variable _hp_cfg_detail_level value in the Per-Client configuration
file can be set as follows:
_hp_cfg_detail_level="ivst"
where t is for post_config_script selection settings.
This sets the install_default_printer script to be run as a post-installation process on
the client. This line should stand alone, and be placed outside of any clauses in the file (such
as a sw_sel clause). The script set to execute with the post_config_script variable
executes after all software has been installed and the system has been booted with its final
kernel, but before any of the normal /etc/rc startup scripts have been run.
You can change the default installation script behavior from the Actions menu, by choosing
Install Client, and then choosing New install. Then click on the Advanced tab and select the
post-installation scripts that you want to be executed.
TIP: If you want to make a script available under all configurations, add it to the /var/opt/
ignite/data/INDEX file. For example, to execute the install_default_printer script
following every client installation, add the following line to the end of this file:
scripts {"/var/opt/ignite/scripts/install_default_printer"}
This script is made available for selection on the Advanced tab for all configurations. For more
information, see “Advanced Tab” (page 144).
170 Customizing Your Installation