Ignite-UX Administration Guide for HP-UX 11i (B3921-90079, October 2013)

IMPORTANT: Ignite-UX version C.7.12.519 supports the recovery of a system with APA configured
on HP-UX 11i v3 March 2011 update or later. Ignite-UX version C.7.14.264 contains additional
fixes for systems with APA configured. HP recommends using Ignite-UX version C.7.14.264 or
later when creating recovery archives for systems configured with APA.
For more information about configuring APAs, see APA Administration Guide available at:http://
h20566.www2.hp.com/portal/site/hpsc/public/psi/home/?sp4ts.oid=4248623
NOTE: Ignite-UX does support recovery of a system that has all available LAN interfaces configured
into aggregate LAN interfaces.
Care should be taken when modifying network information via the Ignite-UX user interface. Without
a good understanding of how the aggregate LAN interfaces are setup on a system, modifying
network information during a recovery may lead to errors during or after the recovery.
WARNING! Support for APA in Ignite-UX is new and there may be issues discovered with Ignite-UX
and APA which are discovered late for inclusion into this manual. Due to this, if you encounter any
issues with APA and Ignite-UX, see Ignite-UX Frequently Asked Questions available at:
http://www.hp.com/go/sw-deployment-docs under the FAQ entry titled Does Ignite-UX Support
Auto-Port Aggregation (APA)?. The FAQ entry contains information about known problems and
information about what is or is not supported when using APA and Ignite-UX.
System Recovery 197