Ignite-UX Administration Guide for HP-UX 11i (B3921-90079, October 2013)

this is the case, you will need to use the search command to list the devices on the HBA the tape
drive is connected to. See your system’s Operations Guide for details on the search command.
A third way to find the EFI device path is to use the tape drive’s hardware path as a map to it. The
ioscan -fkeCtape command will list the hardware path of the tape drive.
For our example, the hardware path is 0/1/1/1.4.0
Use the following diagram to map the hardware path to the EFI device path:
Figure 99 Mapping the Hardware Path to the EFI Device Path
Configuring the Tape Boot Option
Reboot your system and stop the process at the EFI menu before it times-out, as shown in the figure
below. Notice the last line warns that reboot will occur after the remaining seconds expire.
Figure 100 EFI Menu With Timer
Select Boot Configuration from the Boot Menu.
System Recovery 201