Ignite-UX Administration Guide for HP-UX 11i (B3921-90080, November 2013)

Figure 49 Client Console Awaiting Server Action
Configuring the Installation
To begin the installation, select a client by clicking on its icon, and then select one of the following
from the Actions menu:
— Install Client->New Install... to install a new client as described in “New Installation” (page 117).
— Install Client−> Repeat Install... to use the configuration of a previously installed client as
described in “Repeat an Installation” (page 146).
Figure 50 Ignite-UX Actions Menu
New Installation
The new installation procedure follows a linear path until the client installation configuration interface
is displayed . At that point, the amount of configuring done is at your discretion.
Configuring the Installation 117