HP Insight Control for Linux 6.0 User Guide

1 Warning
2 Critical
other
Unknown
3
The name of the Nagios service description. For more information, see the corresponding
/opt/hptc/nagios/etc/templates/*_template.cfg template file.
4
The alert applies to this host name.
5
The IP address of the host.
6
The message text generated from the plug-in.
In the following example, <icelx47> indicates that this data was collected by the Nagios
monitor running on icelx47. The message is from the plug-in associated with the Nagios
service for the System Event Log, in this case, the /opt/hptc/nagios/libexec/
check_sel log file.
<icelx47> Power Unit Power Redundancy Redundancy Lost
7
A date and time stamp indicating when the cause for the alert happened.
8
Indicates how much time the message waited in the nand queue before it was mailed.
9
The nand sequence number. The nand daemon receives and batches messages generated
by Nagios and sends them by email.
14.6 Understanding system event log monitoring
The firmware on HP servers captures platform-specific events to track hardware states and
changes. The events are stored in a System Event Log. Information in the System Event Log
varies, but it typically contains information including, but not limited to, the following:
• Memory ECC errors
• Power supply failures
• Voltage problems
HP Insight Control for Linux is configured to alert you of errors that indicate failure or pending
failure of a component.
Log information is regularly read, archived, and used to generate Nagios alerts based on the
rules defined in the /opt/hptc/nagios/etc/selRules file.
Event logs are accessed through the management port. They require platform- and
protocol-specific user authentication as well as network access to the console port.
System Event Log history is captured in /hptc_cluster/adm/logs/sel/sel-xxx.log,
where xxx represents the name of the individual managed system.
Logs are managed by the standard logrotate functionality. For more information, see
logrotate(8).
14.7 Configuring Nagios email alerts
Nagios sends email by default to the nagios user.
The simplest method to forward email alerts is to log in as the Nagios user and to create a
.forward file in the Nagios user's home directory (usually /home/nagios) to redirect email
alert messages from Nagios to another email account. This method assures that the permissions
on the .forward file are correct.
NOTE:
Ensure that the sendmail utility is running.
Edit the /opt/hptc/nagios/etc/contacts.cfg file to customize the Nagios configuration
to specify whom to contact. The main portion of this file is shown here:
14.6 Understanding system event log monitoring 167