HP Insight Control for Linux 6.2 User Guide

25.17 Troubleshooting PXE Boot problems
The following table provides the actions to correct a possible PXE boot failure.
Corrective ActionsCause/Symptom
To reestablish PXE boot capability:
1. Press Enter to view the Option ROM message.
2. When the ServerEngine information is displayed, enter
Ctrl-P to configure it.
3. Select the appropriate port.
4. Change the Boot Support setting to Enable.
5. Select Save.
6. Select Save again and exit the utility.
Updating NIC might result in temporary loss of PXE
boot capability
25.18 Troubleshooting the run script and run SSH command tools
The following table describes possible causes of problems with running scripts and commands
and provides actions to correct them.
Corrective actionsCause/Symptom
• Review the task log for the Run Script tool; verify that
there is no error message.
• Look at the exit code from the remote process. A
nonzero exit code indicates failure.
• Examine the script for any file descriptors that remain
open when the script exits.
Run Script Fails
The script run on the target system returned an exit code
indicating failure.
Verify that the script was uploaded to the system and
exists in the Insight Control for Linux repository.
Run Script Does Not Exist In the Repository
The script you want to run is absent from the Insight
Control for Linux repository.
• Review the task log for the Run SSH Command tool;
verify that there is no error message.
• Look at the exit code from the remote process. A
nonzero exit code indicates failure.
• Examine the command for any file descriptors that
remain open when the script exits.
Run SSH Command Fails
The command line you entered in the Enter the SSH
Command Line Window to run on the target system
returned an exit code indicating failure.
25.17 Troubleshooting PXE Boot problems 249