HP Insight Management 7.3 Installation and Configuration Guide

Figure 17 VCEM—MAC and WWN range selection
NOTE: If you do not want to provide the range information, you must not select the checkbox.
If the checkbox is cleared, the drop-down list is no longer available, and theVCEM Defined range
(128k addresses) label appears.
If you do not select the option I (will) use multiple CMS, then after the DVD installation is complete,
you can perform this step by manually configuring the exclusion ranges directly on VCEM page
from HP SIM. In this case, it is possible to select the pre-defined ranges or fill a customized range
for MACs and WWNs to each CMS.
1. On the VCEM Range Selection screen, select the I (will) use multiple CMS checkbox.
Both the VCEM MAC Range and the VCEM WWN Range is enabled for selecting the range
of addresses.
2. Select the range values for both VCEM MAC range and VCEM WWN range from the list of
addresses available in the drop-down list.
VCEM-Subrange selections from 1 through 128 are available for both VCEM MAC range
and VCEM WWN range.
Step 17: Selecting the sub-range addresses for HP Virtual Connect Enterprise Manager 31