HP Insight Control Server Provisioning 7.2 Administrator Guide

virtual appliance. Look for the files with .current extension. There are different agent files
depending on the operating system version and architecture type.
The SA Agent files are listed below:
SA Agent to downloadOperating System
opsware-agent-NT-6.0-X64.currentWindows 2008 x64
opsware-agent-NT-6.1-X64.currentWindows 2008 R2 x64
opsware-agent-NT-6.2-X64.currentWindows 2012 x64
opsware-agent-LINUX-5SERVER-X86_64.currentRed Hat EL 5.x
opsware-agent-LINUX-6SERVER-X86_64.currentRed Hat EL 6.x
opsware-agent-LINUX-SLES-11-X86_64.currentSLES 11
NOTE: There is no SA agent that runs on VMware ESXi.
2. Download the SA agent using the exact filename in the url without the .current extension,
http://xxx.xxx.xxx.xxx:8081/<filename> where <filename> is name of the SA
agent file.
IMPORTANT: Do not download the file by listing all the agent files and then using the
right-click Save link to save it. The file will contain only HTML content and not work with IC
server provisioning.
3. Once a Windows agent file is downloaded, rename the filename with a .exe extension. For
Linux, the filename without an extension is appropriate.
4. Install the SA agent on the target server with the parameters, –s --opsw_gw_list
coreip:3001 where coreip is the IP address of the IC server provisioning virtual appliance.
Be sure to use the Deployment IP address, not the Appliance IP address.
5. Verify the target server shows up in IC server provisioning.
6. Before an OSBP can be run on this target server, the server’s iLO must also be registered with
IC server provisioning. This can be done by either of the following ways:
a. You can add each target server’s iLO information manually. From the IC server provisioning
Servers page, choose Actions→Add Servers, enter the iLO IP address and credentials of
a target server, and be sure to check the box that says Do not boot to maintenance.
Choose Add to initiate the iLO registration or Add+ to enter more IP addresses.
b. You can add each server’s iLO information using the programmatic REST (see“REST call
to add a server via iLO” (page 37)). Be sure to use the option that does not boot the
server into maintenance.
7. You can verify that the iLO has been properly registered with the server by going to the Servers
page and seeing if the iLO IP address is listed there.
42 Advanced topics