HP Insight Control Server Provisioning 7.3 Update 1 Administrator Guide

Example valuesDescriptionName
to the ProLiant Intelligent Provisioning
flash drives. During reprovisioning,
this value might be left over from a
previous installation and cause the
installation to fail. If this happens,
simply delete the custom attribute
before running the Build Plan.
NOTE: During a Windows OS
installation, boot files are always
placed on drive 0. Drive 0 must be
partitioned and formatted for the
Windows installer to access it.
Network name of the installed target
server. This is 15 characters,
maximum. Follow NETBIOS rules.
ComputerName
Windows OS only.
NOTE: If you specify a computer
name with network personalization
when running a Build Plan, it will
override this name.
Used to set the “Administrator”
password in encrypted form.
EncryptedAdminPassword
Refer to the online help topic “Set
(encrypt) the administrator/root
password” for how to create an
encrypted password.
For Linux and ESXi deployment:
“noapci”, “root=LABEL=/”, “quiet”,
“splash”
Used to specify additional arguments
to the kernel where the installation is
running.
kernel_arguments
NOTE: To get your Build Plan to
work for servers with B120i and
B320i controllers, the custom attribute
kernel_arguments must be set to
blacklist=ahci for RHEL
installations or
brokenmodules=ahci for SLES
installations.
Used to set the “root” password in
encrypted form.
encrypted_root_password
Refer to the online help topic “Set
(encrypt) the administrator/root
password” for how to create an
encrypted password.
“sda”, “hdc”, “cciss/c0d1”Describes which disk to install the OS
to.
boot_disk
For Hardware
This is a multi-line custom attribute and
the values are defined in the help topic
Contains information used to configure
an HBA or CNA on a target server
with your appropriate boot LUN.
HBA_Config
Configure the boot device on a Fibre
Channel HBA.
Additional custom attributes
Table of some commonly used custom attributes 41