HP Insight Management 7.2 Update 2 Support Matrix

HP Virtual Connect Enterprise Manager hardware
Table 38 (page 44) lists hardware requirements for Virtual Connect Enterprise Manager.
Table 38 Virtual Connect Enterprise Manager hardware requirements
Minimum requirementComponent
Virtual Connect Ethernet modules
HP Virtual Connect 1/10 Gb Ethernet Module
HP Virtual Connect 1/10 Gb-F Ethernet Module
HP Virtual Connect Flex-10 10 Gb Ethernet Module
HP Virtual Connect Flex-10/10D Module for BladeSystem c-Class
Virtual Connect Fibre Channel modules
HP Virtual Connect 4 Gb Fibre Channel Module
HP Virtual Connect 8 Gb 24-port Fibre Channel Module
HP Virtual Connect 8 Gb 20-port Fibre Channel Module
Virtual Connect FlexFabric
HP Virtual Connect FlexFabric 10Gb/24-port Module for c-Class
BladeSystem
Other supported hardware
As a general rule, Insight Management supports all the following items, and their plug-in equivalents,
assuming that they are installed with the latest firmware and drivers.
External Ethernet switches
Embedded network interface cards (NICs)
Smart Array controllers, host bus adapters (HBAs)
HP BladeSystem mezzanine cards
HP IO Accelerators
For information on the storage controllers, converged network adapters (CNAs), and network
interface cards (NICs) supported by Insight Control server migration, see “Hardware requirements
and caveats for Insight Control server migration” (page 83).
For information on the storage controllers, converged network adapters (CNAs), and network
interface cards (NICs) supported by Insight Control server provisioning, see “Hardware requirements
and caveats for Insight Control server provisioning” (page 90).
For information on the HP IO Accelerators (supported in Matrix OE versions 7.2, 7.2.1, and 7.2.2),
see http://h18004.www1.hp.com/products/storageworks/io_accelerator/index.html. Two
whitepapers are available online that describe the setup and scenarios for using the HP IO
Accelerators at: http://www.hp.com/go/insightmanagement/docs.
44 Managed systems hardware