HP System Management Homepage 7.0 Installation Guide

To configure IP binding:
1. Select IP Binding. The IP Binding page appears.
2. Enter the IP address.
3. Enter the netmask.
Note: The masking field is not required for IPv6 addresses.
4. Click Add. The IP binding configuration is saved and appears under the IP Binding List.
5. Click Next. The IP Restricted Login page appears.
10. The IP Restricted Login enables the HP SMH to restrict login access based on the IP address
of a system.
You can set address restriction at installation time, or administrators can set address restriction
from the IP Restricted Login page
• If an IP address is excluded, it is excluded even if it is also listed in the Included box.
• If there are IP addresses in the Included box, then only those IP addresses are allowed
login access with the exception of localhost.
• If no IP addresses are in the inclusion list, then login access is allowed to any IP addresses
not in the exclusion list.
To include or exclude IP addresses:
1. In the From field, enter the IP addresses to include or exclude. You can enter an IP address
range to be included or excluded by entering a beginning IP address in the From field
and an ending IP address in the To field.
2. From the Type field, select Include or Exclude.
3. Click Add to add the IP address or IP address range to the Inclusion List or Exclusion List.
4. Click Save.
The HP SMH component is configured successfully and is ready for installation.
46 Installing HP SMH using HPSUM