HP Insight Management Agents 9.10 Managing ProLiant Servers with Linux HOW TO Whitepaper

Table 10 Uninstall drivers and agents commands
DescriptionCommand
Removes the hp-snmp-agents package from your system# rpm –e hp-snmp-agents
Removes the hp-ilo package from your system# rpm –e hp-ilo
Removes the hp-health package from your system# rpm –e hp-health
Removes the hp-OpenIPMI package from your system# rpm –e hp-OpenIPMI
CAUTION: If a service is running when the corresponding package is removed, it is automatically
shut down during the removal process.
Transitioning from hpasm, hprsm, and cmanic packages
Prior to the 8.1.0 release, the functionality and files provided by hp-health and
hp-snmp-agents were distributed in alternate packages.
If you have a version of the HP System Health Application and Insight Management Agent (hpasm),
the HP Lights-Out Drivers and Agents (hprsm), or the NIC Agents (cmanic) installed, you must
uninstall these components before installing the new RPM files.
NOTE: If you have any local customizations to the /etc/hpasmrc file, save a copy of that file
before removing the hpasm component. After installing hp-snmp-agents, you can make the
same modifications to the /etc/hp-snmp-agents.conf file.
To determine if these components are loaded, enter the command listed in the To verify installation
column in Table 11: Loaded components. To remove the component, enter the command shown
in the To remove column.
Table 11 Loaded components
To removeTo verify installationComponent
# rpm –e hpasm$ rpm –q hpasmHP System Health Application and
Insight Management Agents
# rpm –e hprsm$ rpm –q hprsmHP Lights-Out Drivers and Agents
# rpm –e hp-OpenIPMI$ rpm –q hp-OpenIPMIHP OpenIPMI Device Driver
# rpm –e cmanic$ rpm –q cmanicNIC Agents
NOTE: Remove cmanic and hprsm components before removing hpasm because of driver
dependencies.
If concurrent access on the RPM database is attempted, the following messages can result:
• rpmQuery: rpmdbOpen() failed
• cannot get shared lock on database
• rpmQuery: rpmdbOpen() failed
Updating drivers and agents
The following section provides information on updating the HP ProLiant Management Software for
Linux. Note that these instructions are only appropriate when upgrading from software with a
version greater than 8.1.0. For information on transitioning from pre-8.1.0 versions, see
“Transitioning from hpasm, hprsm, and cmanic packages” on “Transitioning from hpasm, hprsm,
and cmanic packages” (page 19).
Transitioning from hpasm, hprsm, and cmanic packages 19