HP Insight Management Agents 9.10 Managing ProLiant Servers with Linux HOW TO Whitepaper

Table 15 cpqriisd messages (continued)
DetailsMessage Number
These messages indicate a problem that occurred during
initialization of the service. The main reasons for failure include:
Description
• Absence of the iLO driver
• iLO encountered problems and is in an undefined state
• The operating system is running out of resources (for example,
memory, threads, semaphores, and so on)
Verify that the iLO Driver is installed and reboot the server.Recommended action
start failed. started and stopped. – failed.Message 11
This message indicates that the service terminated itself because of
problems.
Description
Install Version 1 .1 .0-2 of the service. Verify that the iLO driver is
installed and reboot the server. If the problem persists, contact your
HP field service Engineer.
Recommended action
Dispatcher still sees %d clients...Message 12
A client does not respond properly to impending shut down.
Consequently the service waits for approximately 5 seconds, outputs
this message, and exits.
Description
No action is required, since this message is informational. However,
this message could also indicate that the HP ProLiant Rack Daemon
(cmarackd) has died.
Recommended action
Checksum on EEPROM %2.2x do not match for header (%2.2x)Message 13
This message indicates that the EEPROMs in the infrastructure are
corrupt.
Description
Contact your HP field service engineer for resolution.Recommended action
Error: copy ipmb response with negative length %dMessage 14
Error: copy ipmb response with excessive length %d
These messages indicate that a corrupt response from the
infrastructure was received.
Description
Reboot the HP ProLiant Power Module.Recommended action
30 Error messages