Microsoft Windows Event ID and SNMP Traps Reference Guide

the Management Agents service. If the error persists, reinstalling the Management Agents may
correct this error.
Event identifier: cpqnimsg.dll - 1039 (Hex)0x4435040f (Service Event)
Log Severity: Information (1)
Log Message: The NIC SNMP Management Agent has determined the Insight Agent Management
service is running.
Event identifier: cpqnimsg.dll - 1040 (Hex)0x44350410 (Service Event)
Log Severity: Information (1)
Log Message: The agent could not deliver trap %1. The agent was unable to use Asynchronous
Management to deliver a trap. This can be caused by a failure in the Remote Access Service or
by a missing or invalid configuration. Use the Insight Agent control panel to verify the Asynchronous
Management configuration settings. Use the Network control panel to verify the Remote Access
configuration. If this error persists, reinstalling the Insight Agents or the Remote Access Service may
correct this error. For more information, see the Insight Asynchronous Management documentation.
NT Event ID: 1290 (Hex)0x4435050A (cpqnimsg.dll)
Log Severity: Information (1)
Log Message: Connectivity has been restored for the NIC in slot %1, port %2.
SNMP Trap: cpqNic3ConnectivityRestored - 18011 in CPQNIC.MIB
Symptom: This trap is sent any time connectivity is restored to a logical adapter. This occurs when
the physical adapter in a single adapter configuration returns to the OK condition or at least one
physical adapter in a logical adapter group returns to the OK condition. This can be caused by
replacement of a faulty cable or re-attaching a cable that was unplugged.
User Action: None required.
Supporting SNMP Trap Data:
• sysName
• cpqHoTrapFlags
• cpqNicIfPhysAdapterSlot
• cpqNicIfPhysAdapterPort
• cpqSiServerSystemId
• cpqNicIfPhysAdapterStatus
• cpqSePciSlotBoardName
• cpqNicIfPhysAdapterPartNumber
• ipAdEntAddr
• cpqNicIfLogMapIPV6Address
Supporting SNMP Trap Description: “Connectivity is restored for adapter in slot
[cpqNicIfPhysAdapterSlot], port [cpqNicIfPhysAdapterPort].”
NT Event ID: 1291 (Hex)0xc435050B (cpqnimsg.dll)
Log Severity: Error (3)
Log Message: Connectivity has been lost for the NIC in slot %1, port %2.
SNMP Trap: cpqNic3ConnectivityLost - 18012 in CPQNIC.MIB
Symptom: This trap is sent any time the status of a logical adapter changes to the Failed condition.
This occurs when the adapter in a single adapter configuration fails, or when the last adapter in
a redundant configuration fails. This can be caused by loss of link due to a cable being removed
from the adapter or the Hub or Switch. Internal adapter, Hub, or Switch failures can also cause
this condition.
126 NIC agents