Microsoft Windows Event ID and SNMP Traps Reference Guide

Log Message: The Fibre Channel tape drive on tape controller with world wide name “%4”, SCSI
bus %5, SCSI target %6, requires cleaning.
SNMP Trap: cpqFcTapeDriveCleaningRequired - 16012 in CPQFCA.MIB
Symptom: Fibre Channel Tape Drive Cleaning Required trap. The agent has detected a tape drive
that needs to have a cleaning tape inserted and run. This causes the tape drive heads to be cleaned.
Supporting SNMP Trap Data:
• sysName
• cpqHoTrapFlags
• cpqFcTapeCntlrWWN
• cpqFcTapeDriveScsiBus
• cpqFcTapeDriveScsiTarget
• cpqFcTapeDriveScsiLun
Supporting SNMP Trap Description: “Cleaning is needed for tape drive.”
NT Event ID: 1178 (Hex)0x8435049a (cpqstmsg.dll)
Log Severity: Warning (2)
Event Title: Fibre Channel Tape Drive Replace Cleaning Tape.
Log Message: The cleaning tape in the Fibre Channel tape drive on tape controller with world
wide name “%4”, SCSI bus %5, SCSI target %6, needs to be replaced.
SNMP Trap: cpqFcTapeDriveCleanTapeReplace - 16013 in CPQFCA.MIB
Symptom: Fibre Channel Tape Drive Cleaning Tape Needs Replacing. The agent has detected
that an autoloader tape unit has a cleaning tape that has been fully used and therefore needs to
be replaced with a new cleaning tape.
Supporting SNMP Trap Data:
• sysName
• cpqHoTrapFlags
• cpqFcTapeCntlrWWN
• cpqFcTapeDriveScsiBus
• cpqFcTapeDriveScsiTarget
• cpqFcTapeDriveScsiLun
Supporting SNMP Trap Description: “Cleaning tape needs replacing.”
NT Event ID: 1179 (Hex)0x8435049b (cpqstmsg.dll)
Log Severity: Warning (2)
Event Title: External Array Controller Active.
Log Message: The external controller in I/O slot %5 of array “%4” has become the active controller.
SNMP Trap: cpqFcaCntlrActive - 16014 in CPQFCA.MIB
Symptom: Fibre Array Controller Active. This trap indicates that the Storage Agent has detected
that a backup array controller in a duplexed pair has switched over to the active role. The variable
cpqFcaCntlrBoxIoSlot indicates the new active controller index.
User Action: Check the partner controller for problems. If this was the result of a user initiated
switch-over, no action is required.
Supporting SNMP Trap Data:
• sysName
• cpqHoTrapFlags
Event Identifiers 1101-1199 47