HP-UX Virtual Partitions Administrator's Guide (includes A.03.04) (previously titled Installing and Managing HP-UX Virtual Partitions)

Installing, Updating, or Removing vPars and Upgrading Servers with vPars
Installing vPars with Ignite-UX on Integrity
Chapter 4
117
# vparboot -p <target_partition> -I
For our example, if the target partition is keira2, execute the following command from keira1:
# vparboot -p keira2 -I
You will see messages similar to the following:
<MON> keira2 loaded
b. press Ctrl-A until you see the console of the target partition.
[keira2]
c. Select a MAC address from the list to perform a LAN boot.
01 Acpi(000222F0,0)/Pci(1|0)/Mac(00306E0E5268)
Select Desired LAN: 1
Selected Acpi(000222F0,0)/Pci(1|0)/Mac(00306E0E5268)
Running LoadFile()
CLIENT MAC ADDR: 00 30 6e 0e 52 68
DHCP…
d. Using the Ignite-UX server, install the necessary bundles.
This includes HP-UX OE, any desired patches, the Quality Pack bundle, the vPars bundle, and any
desired vPars-related bundles.
Your system should now be booted with all virtual partitions up.