HP Superdome 2 Partitioning Administrator Guide (5900-2540, December 2012)

Figure 8 nPartition Status Information
Removing an nPartition
This section describes the procedure to remove an nPartition using both the OA interfaces.
Removing an nPartition using the OA CLI
The parremove command removes an existing nPartition by unassigning all blades and I/O bays
from the nPartition. The target nPartition must be inactive unless the -F option is used. By default,
the current partition specification (parspec) associated with the nPartition is not removed when
the nPartition is removed. The current parspec associated with the nPartition becomes an alternate
parspec and can be reused later. If the -Z option is specified, the command removes the current
parspec when the nPartition is removed.
To remove an nPartition, use the parremove command:
parremove -p nPartition_id [-Z] [-F]
For example:
parremove -p 2
Removing (Deleting) an nPartition using the OA GUI
To remove an inactive nPartition, select the check box corresponding to the nPartition name from
the Complex nPartitions table, and then click Delete.
Renaming an nPartition
This section describes the procedure to rename an nPartition using both the OA interfaces.
Renaming an nPartition using the OA CLI
Use the parmodify command to rename the nPartition:
parmodify -p <nPar_id> -P <new_nPartition_name>
where, <nPar_ID> is the integer nPartition number which indicates which nPartition is getting
renamed, and new_nPartition_name is the new name for the nPartition.
42 Creating and configuring nPartitions