HP-UX GUID Manager v1.0 Administrator Guide

NOTE: In this scenario, GUID client is not set up to communicate with the GUID server. You
must perform a manual configuration, so that the GUID client can communicate with the GUID
server.
3. To manually add a GUID server to your GUID client configuration, use the following commands:
:/opt/guid/bin/guidconfig –h hostname
:/opt/guid/bin/guid_client_prepare –m hostname
NOTE: Any time you use the /opt/guid/bin/guidconfig –h hostname command,
you must also use the /opt/guid/bin/guid_client_prepare -m command to enable
the GUID client to communicate with the GUID server:
• The guid_client_prepare command sets up the GUID client SSH tunnel to the GUID
server.
• The guidconfig command updates the configuration file.
See the following example:
:/opt/guid/bin/guidconfig -h hptem027
HOST=hptem027
:/opt/guid/bin/guid_client_prepare -m hptem027
Install pubkey on GUID server(hptem027) succeeded.
No wwn range is set on GUID server(hptem027).
GUIDMGR client preparation accomplished.
4.4 GUID Manager Examples 19