HP-UX Virtual Partitions Administrator Guide (includes A.05.07) (5900-1229, September 2010)

Setting Up the Ignite-UX Server
If you are having problems with terminal emulation, see also “Ignite-UX and other Curses
Applications” (page 22).
For complete information on Ignite-UX, see the document Ignite-UX Administration Guide.
Ignite-UX Versions
vPars A.03.xx and A.04.xx have different version requirements. This version information has
been moved to the HP-UX Virtual Partitions Ordering and Configuration Guide.
NOTE: PA-RISC only: When using Ignite-UX version C.06.xx or later, the bootable kernel path
has changed from /opt/ignite/boot/WINSTALL in Ignite-UX B.05.xx and earlier to/opt/
ignite/boot/Rel_B.11.NN/WINSTALL in Ignite-UX C.06.xx and later.
Thus, when using Ignite-UX C.06.xx or later, you must specify the absolute path for the bootable
kernel for the vparboot -Icommand line. For more information and an example, see “(PA-RISC
only) The WINSTALL Boot Kernel Paths with Different Versions of Ignite-UX and the vparboot
-I command” (page 21).
Determining the Ignite-UX Version
To determine which version of Ignite-UX you are running, execute the command similar to:
# swlist -l fileset -a revision Ignite-UX.FILE-SRV-11-11
Example
If your swlist output shows
# Initializing...
# Contacting target "rust"...
#
# Target: rust:/
#
Ignite-UX.FILE-SRV-11-11 B.5.4.50
then your Ignite-UX version is B.5.4.50.
Ignite-UX Cookbook
For information on how to install an Ignite-UX server, install HP-UX using Ignite-UX, and recover
clients from media or over the network, see the document Ignite-UX Administration Guide.
Setting Up the Ignite-UX Server 77