HP-UX Virtual Partitions Administrator Guide (includes A.05.07) (5900-1229, September 2010)

— Wait for the vPars A.03.05 update to complete on all but the last virtual partition.
Monitor the installation logs (such as the /var/adm/sw/swagent.log file or
swinstall.log file) until the virtual partitions halt.
— On the last virtual partition, update the HP-UX Operating Environment, if needed,
and update the vPars bundle.
12. Make sure that all virtual partition updates have successfully completed to the point of
halting, then reboot the nPartition (reboot from the vPars Monitor).
13. Interrupt the nPartition boot process as needed and load the vPars A.04.05 Monitor.
14. Boot all virtual partitions (vparload -all from the vPars Monitor).
15. Turn autoboot and autosearch settings back to their original settings that you recorded
previously.
16. Verify the virtual partition configurations.
17. Verify the correct vPars Monitor has been booted.
18. Restart gWLM if needed.
Following the mixed HP-UX 11i v1/v2 vPars update, perform any application updates as needed.
88 Installing, Updating, or Removing vPars and Upgrading Servers with vPars