HP-UX Virtual Partitions Administrator's Guide (includes A.03.05 and A.04.05)

After vPars is installed and running, you must boot at least one virtual partition to a HP-UX
kernel. You can then start the virtual partition manager in that virtual partition by executing the
command vparmgr
/opt/vparmgr/bin/vparmgr [-h]
/opt/vparmgr/bin/vparmgr -tcreate
/opt/vparmgr/bin/vparmgr -tmodify|par_details -pvp_name
With no arguments, the vparmgr graphical user interface is launched. You can perform all
vparmgr operations from the GUI, as discussed below under using the graphical user interface.
Options
-h
displays usage instructions
-tcreate
creates a new virtual partition
-tmodify
modifies an existing virtual partition. You must specify which virtual partition to modify, using
the vp_name parameter.
-tpar_details
displays the status, attributes, and resources of a virtual partition. You must specify which virtual
partition to display, using the vp_name parameter.
vp_name
the name of a virtual partition
Using the vPars Graphical User Interface (GUI)
When the vparmgr GUI starts, it displays the virtual partition status screen.
Figure 12-1 vPars GUI Status Screen
This displays the status of all of the virtual partitions and available resources on the system. To
perform an action on an object (a virtual partition or a set of available resources), click on the
object in the list and then click the button corresponding to the action that you want to perform
296 Virtual Partition Manager (A.03.xx)