HP-UX Virtual Partitions Ordering and Configuration Guide (May 2012)

EVAs with Secure Path EVAs with Secure Path are supported as follows:
Secure Path 3.0d
and LaterSecure Path 3.0c
Prior to Secure
Path 3.0c
SupportedUnsupportedUnsupportedvPars Boot and
Dump
SupportedSupportedUnsupportedvPars Data
4.4.7 Interconnects
vPars supports the HP Hyperfabric products and protocols (HMP, TCP, UDP, IP). All interconnects,
including hubs, switches, and fibre channel storage arrays, that are supported for HP-UX without
vPars are supported for HP-UX with vPars, with exceptions noted below.
vPars A.05.xx, vPars A.04.xx
J3525A (X.25) cards cannot be used with vPars on Integrity systems at this time (see JAGag33474).
You must use the firmware version that is noted in the A.03.xx section below (or a later firmware
version).
vPars A.03.xx
• The following interconnect hubs and switches are supported with vPars as follows.
Firmware Version (If Applicable)Switch or Hub
—FC S10 hub
2.6.1cBrocade 2400/2800 1Gb
3.1.1cBrocade 3800 1Gb/2Gb
4.0.2b, 4.1.2bBrocade 12000
04.01.02 or 05.01.00-24StorageWorks Edge 2/24, McData 2/24
05.02.00-13StorageWorks Director 2/64, EMC ED-64M, McData
FC64, McData Director 2/64
05.02.00-13McData 2/32, McData 2/16
• The following interconnect storage device firmware versions are supported with vPars as
follows.
Firmware Version (If Applicable)Device
HP18VA7110
21-03-03XP1024
HP05SC10
HP62Icicle
5669, 5670EMC 6.0
—DS2100
4.4 Supported Cards 63