HP-UX Virtual Partitions Release Notes (A.05.09)

Current Automatic System restart: Enabled
Do you want to modify it? (Y/[N]) y
New Automatic System restart (Enabled / Disabled): disabled
New Automatic System restart: Disabled
Confirm? (Y/[N]): y
-> Automatic System restart will be updated.
Current Triggering alert levels are: 13
Do you want to modify them? (Y/[N]): n
Automatic System Restart configuration has been updated
GSP Host Name: keira
GSP>
◦ On nPartitionable servers, use the following procedure:
GSP> cm
Enter HE to get a list of available commands
GSP:CM> ar
This command modifies the automatic system restart
configuration of
the selected partition.
# Name
--- ----
0) vpar8cell
1) vpar4cell
2) vpar3cell
Select a partition number: 2
Automatic system restart for partition 2 is currently
enabled.
Do you want to disable automatic system restart? (Y/[N]) y
-> Automatic system restart is disabled.
GSP:CM>
• Topology of A5158A Changes from Fabric to Public Loop After the Virtual
Partition Reboots
Related Defect ID and Patch Number
JAGaf15533
Applicable On
◦ vPars A.05.xx on PA-RISC
◦ vPars A.04.xx on PA-RISC
◦ vPars A.03.xx on PA-RISC
Description
When the A5158A is connected to the Brocade 2800 or 12000 switch, the topology of the
A5158A changes after the virtual partition reboots.
Symptoms
◦ Before a reboot, the topology shows PTTOPT_FABRIC:
vpar1# tdutil /dev/td0
Vendor ID is = 0x00103c
Device ID is = 0x001028
TL Chip Revision No is = 2.3
PCI Sub-system Vendor ID is = 0x00103c
PCI Sub-system ID is = 0x000006
Topology = PTTOPT_FABRIC
...
◦ After a reboot, the topology shows PUBLIC_LOOP:
14 vPars A.05.09 Release Notes