Fabric OS Encryption Administrator's Guide

94 Fabric OS Encryption Administrator’s Guide

53-1002159-03

Viewing time left for auto re-key

You can view the time remaining until auto re-key is no longer active for a disk LUN. The information

is expressed as the difference between the next re-key date and the current date and time, and is

measured in days, hours, and minutes.

Although you cannot make changes directly to the table, you can modify the time left using CLI. For

more information, see Chapter 3, “Configuring Brocade encryption using the CLI.”

To view the time left for auto re-key, follow these steps:

1. Select Configure > Encryption.

The Encryption Center dialog box displays.

2. Select a group, switch, or engine from the Encryption Center Devices table for which to view the

auto re-key information, then select Group/Switch/Engine > Targets from the menu task bar,

or right-click a group, switch, or engine and select Targets.

NOTE

You can also select a group, switch, or engine from the Encryption Center Devices table, then

click the Targets icon.

The Encryption Targets dialog box displays.

3. Select a target disk device from the table, then click LUNs.

The Encryption Target Disk LUNs dialog box displays. From this dialog box, you can view the

time left for auto re-key information.

FIGURE 78 Time left for auto re-key