Fabric OS Encryption Administrator's Guide

64 Fabric OS Encryption Administrator’s Guide

53-1002159-03

Configuring hosts for encryption targets

Use the Encryption Target Hosts dialog box to edit (add or remove) hosts for an encrypted target.

NOTE

Hosts are normally selected as part of the Configure Storage Encryption wizard but you can also edit

hosts later using the Encryption Target Hosts dialog box.

1. Select Configure > Encryption from the menu task bar.

The Encryption Center dialog box displays.

2. Select a group, switch, or engine from the Encryption Center Devices table that contains the

storage device to be configured, then select Group/Switch/Engine > Targets from the menu

task bar, or right-click a group, switch, or engine and select Targets.

NOTE

You can also select a group, switch, or engine from the Encryption Center Devices table, then

click the Targets icon.

The Encryption Targets dialog box displays.

3. Select a Target storage device from the list, then click Hosts.

The Encryption Target Hosts dialog box displays. This dialog box lists configured hosts in a

fabric.

FIGURE 51 Encryption Target Hosts dialog box

4. Select one or more hosts in a fabric, then move them to the Selected Hosts table using the

right arrow, or manually enter world wide names in the Port WWN and Node WWN text boxes if

the hosts are not included in the list. You must fill in both the Port WWN and the Node WWN.

Click Add to move the host to the Selected Hosts list.