Fabric OS Encryption Administrator's Guide

Fabric OS Encryption Administrator’s Guide 65
53-1002159-03
Adding target disk LUNs for encryption
2
Adding target disk LUNs for encryption
You can add a new path to an existing disk LUN or add a new LUN and path by launching the Add
New Path wizard. Take the following steps to launch the Add New Path wizard.
Before You Begin
Before you can add a target disk LUN for encryption, you must first configure the Storage Arrays.
For more information, see “Configuring Storage Arrays” on page 68.
1. Select Configure > Encryption from the menu task bar.
The Encryption Center dialog box displays.
2. Select a group, switch, or engine from the Encryption Center Devices table, then select
Group/Switch/Engine > Disk LUNs from the menu task bar, or right-click a group, switch, or
engine and select Disk LUNs.
The Encryption Disk LUN View dialog box displays.
FIGURE 52 Encryption Disk LUN view dialog box
3. Click Add.
The Select Target Port dialog box displays.
FIGURE 53 Select Target Port dialog box