HP LaserJet 4050, 4050N, 4050T and 4050TN Printers - User's Guide

EN
Chapter 4: Problem Solving 117
Light Print or Fade
Toner Specks
Dropouts
Lines
Gray Background
Toner Smear
Loose Toner
Repeating
Defects
Misformed
Characters Page Skew
Curl or Wave
Wrinkles or
Creases
Troubleshooting Steps
(Follow the steps in the
order they are listed.)
✓✓✓✓✓ ✓
1. Print a few more pages to see if the
problem will correct itself.
✓✓✓
2. Clean the inside of the printer (page 83)
or use the printer’s cleaning page
(page 86).
✓
3. Make sure EconoMode is off in the
software and in the control panel
(page B-9).
✓✓
4. Turn over the stack of paper in the tray.
Also try rotating the paper 180°.
✓✓ ✓ ✓ ✓ ✓ ✓ ✓✓✓
5. Check the paper (or other print media)
type and quality (pages A-2
through A-14).
✓✓ ✓ ✓✓
6. Check the printer’s environment
(page A-16).
✓✓
7. Make sure paper is loaded correctly and
that the guides fit properly against the
paper stack. (See the sections on
loading paper, starting on page 34.)
✓✓
8. Print to a different output bin (page 32).
✓✓ ✓
9. Adjust the toner density setting
(page B-9).
✓✓
10.Change the fuser mode setting to High
(page B-6) or choose rough paper type
from the printer driver (page 65).
✓
11.Redistribute the toner in the toner
cartridge (page 81).
✓✓✓✓✓ ✓✓
12.Install a new HP toner cartridge. (See
instructions with the toner cartridge.)
✓✓
13.To alternate small and standard paper,
from the Configuration Menu set
SMALL
PAPER SPEED=SLOW
.
✓✓ ✓ ✓✓ ✓
14.Order and install the Printer
Maintenance Kit (page 11 and
page 87).
✓✓✓✓✓✓✓✓✓✓✓✓
15.After trying all the steps suggested
above, contact an HP-authorized
service or support provider. (See the
HP Customer Care Service and
Support pages at the front of this user’s
guide.)