HP PCL/PJL reference - PCL 5 Comparison Guide Addendum

24 Chapter 2 PCL 5 feature support ENWW
Raster graphics
Raster Resolution ?*t#R
75 Dots per
inch (dpi) [75]
✓✓✓✓
100 dpi [100] ✓✓✓✓
150 dpi [150] ✓✓✓✓
200 dpi [200]
1
✓✓✓✓
300 dpi [300] ✓✓✓✓
600 dpi [600]
1
✓✓✓✓
Graphics Presentation ?*r#F ✓✓✓✓
Raster Height [Source] ?*r#T ✓✓✓✓
Raster Height [Destination] ?*t#V ns ns ns ns
Raster Width [Source] ?*r#S
✓✓✓✓
Raster Width [Destination] ?*t#H ns ns ns ns
Scale Algorithm ?*t#K ns ns ns ns
Start Raster Graphics ?*r#A
At logical page left
limit [0]
✓✓✓✓
At CAP [1] ✓✓✓✓
At logical page left limit,
with scaling ON [2]
ns ns ns ns
At CAP, with
scaling ON [3]
ns ns ns ns
Y Offset ?*b#Y
✓✓✓✓
Set Compression Mode ?*b#M
Unencoded [0]
✓✓✓✓
Run-Length Encoded [1] ✓✓✓✓
TIFF Encoded [2] ✓✓✓✓
Delta Row Encoded [3] ✓✓✓✓
Mode 5 Adaptive [5] ✓✓✓✓
Replacement Delta
Row [9]
ns ns ns ns
Transfer Raster (Row/
Block)
?*b#W[data]
✓✓✓✓
Transfer Raster (Plane) ?*b#V[data] ns ns ns ns
End Graphics
Version B ?*rB
✓✓✓✓
Version C (Preferred) ?*rC ✓✓✓✓
✓ - Indicates a command is supported. ns - Indicates a command is not supported.
The information contained in this table is subject to change without notice. To ensure that the specific
support information is correct, test these functions and commands on your product.
1
Supported if the printer resolution is 600 dpi.
Table 3. PCL 5 feature support for LaserJet products (continued)
Functions Commands LaserJet
4100
series
LaserJet
4100mfp
series
LaserJet
4200
series
LaserJet
4300
series