HP LaserJet 9040/9050 - User Guide

ENWW Configure device menu 169
DEFAULT PAPER
TYPE
PLAIN
PREPRINTED
LETTERHEAD
TRANSPARENCY
PREPUNCHED
LABELS
BOND
RECYCLED
COLOR
CARDSTOCK>163
ROUGH 90-105 G/M2
ENVELOPE *
Allows the user to specify the type of media in each tray.
Substitute the tray number for <N>.
*ENVELOPE appears for Tray 1 only.
DEFAULT CUSTOM
PAPER SIZE
UNIT OF MEASURE
X DIMENSION
Y DIMENSION
Allows the user to set a custom paper size for any of the
installed trays. Substitute the tray number for <N>. This
menu only appears when the selected tray custom switch
is in the custom size position. The user selects the X and Y
dimensions of the custom paper size using the ruler labels
in the trays.
PAPER
DESTINATION=
STANDARD OUTPUT
STANDARD OUTPUT
LEFT OUTPUT BIN
STANDARD TOP BIN
Allows the user to configure the output paper bin
destination. Only installed optional bins will appear on the
menu.
DUPLEX=OFF OFF
ON
This item appears only when an optional duplex printing
accessory is installed. Set the value to ON to print on both
sides (duplex) or OFF to print on one side (simplex) of a
sheet of paper.
For more information, see the HP support flyer or go to
www.hp.com/support/lj9050_lj9040
.
DUPLEX
BINDING=LONG
EDGE
LONG EDGE
SHORT EDGE
Allows the user to change the binding edge for duplex
printing. The menu item is displayed when a duplex
printing accessory is installed in the printer and
DUPLEX=ON.
OVERRIDE A4/
LETTER=
NO
YES
NO
This command is used to print on letter-size paper when
an A4 job is sent, but no A4-size paper is loaded in the
printer (or to print on A4-size paper when a letter job is
sent, but no letter paper is loaded in the printer).
MANUAL FEED=OFF OFF
ON
Feed the paper manually from optional Tray 1, rather than
automatically from a tray. When MANUAL FEED=ON and
optional Tray 1 is empty, the printer goes offline when it
receives a print job. It then displays MANUALLY FEED [PAPER
SIZE].
For more information, see Manually feeding paper from
optional Tray 1.
EDGE TO EDGE
OVERRIDE=NO
NO
YES
Turns the edge-to-edge mode on or off for all print jobs.
This mode can be overridden inside a print job by an edge-
to-edge PJL variable.
Item Values Explanation