- Hewlett-Packard Flat Panel Television User Manual

16 Using the TV
To select a three-digit channel number (for example, channel 115):
Complete the following procedure within 4 seconds.
1 Press the 10+ button on the remote control.
2 Press the 1 button.
3 Press the 5 button.
The three-digit channel number can be selected only when the receiving mode is set to Cable in the TV
Country setting on the System Page.
Exit Button
Press the EXIT button to return one level back from each menu in the onscreen display. You can escape
fully out of the On Screen Display (OSD) with the Exit key.
Adjusting the Language Settings
1 Press the ENTER button on the remote control to display the Menu screen.
2 Arrow down and press ENTER button to select the OSD Page.
3 Press the ENTER button to enter the Language selection menu.
4 Press the Right Arrow to select a language.
5 Press the EXIT button to save your selection.
Adjusting the Picture Mode Settings
Press the Picture Mode key on the remote control to display the Standard, Vivid, Favorite, and Movie
brightness settings.
Standard: Fixed brightness for normal viewing conditions.
Vivid: For viewing conditions with higher ambient light.
Favorite: Manual adjustment to user preference.
Movie: For viewing conditions with a darker contrast.
Channel Editing
Follow these steps to add or remove channels from your selection list.
1 Press the ENTER button on the remote control to display the Menu screen.
2 Arrow down and press the ENTER button to select the System Page.
3 Arrow down and press the ENTER button to enter the Channel Edit section.
4 Use the following arrows to add or erase channels:
Right arrow erases the current channel.
Left arrow adds the current channel.
Up and Down arrows scroll through the channels.