HP LeftHand SAN Solutions Support Document - Installation Manual - VSA 8.0 Quick Start - Demo Version

28 Chapter 2
2 In the Information Panel select Edit Settings in the Commands section.
The Virtual Machine Properties window opens.
3 On the Hardware tab, select Network Adapter 1.
4 Select the appropriate network connection from the Network label list on
the right.
Configure a Data Disk
1 Next, click Add at the bottom of the Hardware tab.
The Add Hardware Wizard opens.
Select Device Type
2 Select Hard Disk as the type of device you want to add and click Next.
3 Select Create a new virtual disk and click Next.
Designate Disk Capacity and Location
4 In the Disk Capacity section, designate a capacity that is suitable for the
amount of storage available on your ESX Server.
Refer to Configuring the Capacity of the Data Disk on page 26 for
information about maximum disk size.
5 In the Location section, select Store with Virtual Machine, and click Next.
Advanced Options
6 Select the Virtual Device Node to be SCSI (1:0) in the dropdown menu.
7 Select Mode > Independent > Persistent and click Next.
8 Review the device configuration and click Finish to complete the Add
Hardware wizard.
The Virtual Machine Properties window opens.
9 Click the Resources tab.
10 Select CPU and reserve at least 2000 MHz.
11 Select Memory and reserve 1024 MB.
Warning: Selecting anything other than SCSI 1:0 causes RAID to
be unconfigurable later.