Support Notes for Red Hat Enterprise Linux AS v.4.6 for HP Integrity Servers

a. From the following Web site, click on the "Driver Downloads" link:
http://www.hp.com
b. Click the radio button preceding "Download drivers and software" on the Software &
Driver Downloads page, enter the card number in the text box.
c. Click "Red Hat Enterprise Linux 4 (Itanium)" under the "select operating system" heading
on the specify operating system page.
d. Scroll down the download drivers and software page for your specified card, and click
the download button for the required driver.
2. HP recommends backing up all data and doing a cold install of Red Hat Enterprise Linux
AS v. 4 if upgrading from AS v. 3 or v. 2.1.
3. If the Red Hat kernel detects a VGA card, it defaults to a VGA display. To use serial console,
use the EFI Boot Manager to select the serial device as the primary (or only) console device.
4. The installation of Red Hat Enterprise Linux AS v. 4 may fail if using the autopartition
function on a server with multiple disks. If you encounter this problem, remove all disks
from the server except those on which you are installing Red Hat Enterprise Linux AS v. 4.
Replace the removed disks when operating system installation on the targeted disks is
complete. You may then need to edit the device file name of the /boot/efi mount point
in the /etc/fstab file because the device file may have changed when the disks were
replaced.
5. If you have Red Hat Enterprise Linux AS v. 3 installed on a disk partition on your server
and want to install Red Hat Enterprise Linux AS v. 4 on another, you must change the name
of your boot manager entry on the Red Hat Enterprise Linux AS v. 3 partition because v. 3
and v.4 use the same name for the boot manager entry.
There is no rename function, so from the Boot Option Maintenance Menu in the EFI Boot
Manager, add another boot entry with the same boot parameters as the existing Red Hat
Enterprise Linux AS v. 3 entry, but give it a different name.
6. If you are transitioning to Red Hat Enterprise Linux AS v 4, note that the load order of
storage and networking drivers in this software release is the reverse of the order in Red
Hat Enterprise Linux AS v. 3 and v. 2.1. The numbers on the device file names for your NICs
will appear in the opposite order to which you have become accustomed to seeing them.
7. If using an HP Procurve 4108gl switch with a heavily loaded system, you may experience
intermittent data truncation with FTP transfers through the network. To avoid this problem:
a. Connect to the HP Procurve 4108gl switch using telnet or serial console and login.
b. From the switch command line interface, enter config.
c. Enter no int all lacp.
8. The Red Hat Enterprise Linux AS v. 4 kernel supports maximum memory of 2 TB, which is
also supported by HP.
9. Red Hat Enterprise Linux AS v. 4 does not ship or install a kernel-source rpm with the binary
installation CDs or DVDs. If you want to modify or view the kernel configuration, you must
extract kernel-version.src.rpm from the source .rpm packages. Refer to the Red Hat
Enterprise Linux AS v. 4 Release Notes for instructions.
NOTE: These instructions are in the file RELEASE-NOTES-en, but not in the file
RELEASE-NOTES.
10. 32-bit emulation is not automatically installed with Red Hat Enterprise Linux AS v. 4. To
obtain this functionality, install the ia32el package from the Intel Itanium Extras CD. Then
install any additional compatibility binaries you need from the 32-bit Compatibility Layer
Binaries CD. Refer to the Red Hat Enterprise Linux AS v. 4 Release Notes for instructions.
11. If you use cdrecord to burn a CD, you may need to eject the CD and reinsert before you
can mount it.
8