SVS200 LUN Manager and Volume Manager (T1714-96015, October 2007)

Specifying a Fibre Channel port's information

To perform user authentication in Fibre Channel environments, you must specify information for the Fibre

Channel ports o

fthearray.

1. Start LUN Manager, and display the Authentication pane (Figure 30).

2. In the Port tree, double-click the Subsystem folder. If the array contains Fibre Channel adapters,

the Fibre folder appears below the Subsystem folder. The port's information appears in the Port

Information l

ist.

3. Right-click any point in the Port Information list, and select Port Information. The Set Port Information

pane appears.

Figure 67 Set Port Information pane

Specify the following port information:

• Time out: Time period starting when authentication fails and ending when the next

authentication session ends. This time period is between 15 to 60 seconds. The initial

value is 45 seconds.

• Refusal Interval: Interval beginning when the connection to a port fails and ending when the

next authentication session starts, up to 60 minutes. The initial value is 3 minutes.

• Refusal Frequency: Number of times authentication for connection to a port is allowed,

up to 10 times. The initial value is 3 times.

4. Click OK.

5. Click Apply.Aconﬁrmation message appears.

6. Click OK. Settings are applied to the array.

Registering a Fibre Channel port's user information

1. Start L

UN Manager, and display the Authentication pane (Figure 30).

2. In the

Port tree, double-click the Subsystem folder. If the array contains Fibre Channel adapters, the

Fibre folder appears below the Subsystem folder.

3. In the Port tree, double-click the Fibre folder. Information about the port appears in the tree.

4. Right

-clickanyporticoninthePort tree, and select Default Setting(User Name / Secret).TheDefault

Sett

ing(User Name/Secret) pane appears.

HP StorageWorks LUN Conﬁguration and Security Manager XP user guide for the

XP12000/XP10000/SVS200

121