SVS200 LUN Manager and Volume Manager (T1714-96015, October 2007)

If you double-click an iSCSI port, iSCSI target appears as an icon. The iSCSI name appears on the

right of each ic

on. When

appears, the iSCSI target performs authentication of hosts. When

appears, the iSCSI target does not perform authentication of hosts. By default, appears

for all iSCSI targets.

4. Right-click

an iSCSI target displayed with

,andselectAuthentication Disable -> Enable.TheiSCSI

target's

icon changes to ,andtheportnameappearsinblue.

5. Click Apply.Aconﬁrmation message appears.

6. Click OK. Settings are applied to the array.

To return the iSCSI target setting to

, perform the same operation, except select Authentication Enable

-> Disable in step 4.

Registeringahost'suserinformationonaniSCSItarget

On an iSCSI target that performs authentication of hosts, register the user information for all hosts that

you allow to connect.

1. Start LUN Manager, and display the Authentication pane (Figure 30).

2. In the Port tree, select the port or iSCSI target on which you want to register a host's user information.

The user information for hosts currently registered on the selected port or iSCSI target appears

in the Authentication information (Target) list.

You can register a host's user information even if the port status is

.Inthiscase,however,the

host's registered user information is ignored.

3. Right-click any point in the Authentication information (Host) list, and select Add New User

Information (Host). The Add New User Information (Host) pane appears.

HP StorageWorks LUN Conﬁguration and Security Manager XP user guide for the

XP12000/XP10000/SVS200

125