SVS200 LUN Manager and Volume Manager (T1714-96015, October 2007)

Figure 71 Add New User Information (Host) pane

NOTE:

YoushouldregisteruserinformationforallhoststobeconnectedtoaniSCSItargetthat

performs authentication of hosts. To allow a speciﬁc host to connect to such an iSCSI target

without authentication, conﬁgure the iSCSI target and the host as follows:

•Onthehost:

It does not matter whether or not you conﬁgure the host for authentication by ports with

CHAP.

However, if the host uses Microsoft iSCSI Initiator, do not conﬁgure the host for authentication

by ports with CHAP.

Specify the following user information for the host you want to allow to connect:

• Target Name: Host bus adapter's iSCSI name. Select one from the list or enter the name

directly. In the list, all iSCSI names of host bus adapters connected to the selected port by

the cable appear. For more information about the characters and length you can specify

as an iSCSI name, see iSCSI port and iSNS server settings.

• User Name: Host's user name of the host up to 128 characters.

You can use alphanumeric characters, spaces, and the following symbols in a user name:

.-+@_=:/[],~

User names are case-sensitive. For example, host1 and Host1 represent different users.

• Secret: Secret (that is, a password used in CHAP authentication) between 12 to 32 characters.

You can use the same characters and symbols as a user name in a secret.

• Re-enter Secret:Specifythesecretagainforconﬁrmation.

• Protocol: Protocol used in user authentication. This protocol is ﬁxed to CHAP.

4. Click OK.Thehost'sspeciﬁed user information appears in blue in the Authentication Information

(Host) list.

5. Click Apply.Aconﬁrmation message appears.

6. Click OK. Settings are applied to the array.

Changing a host's user information

You can change a host's registered user name or secret and switch authentication settings between

Enable and Disable after registration.

126

LUN Manager operations