SVS200 LUN Manager and Volume Manager (T1714-96015, October 2007)

NOTE:

• A nickname can consist of up to 32 ASCII characters (letters, numerals, and symbols). However, you

cannot use the following characters for nicknames:

\/:,;*?"<>|

• You cannot use spaces for the ﬁrstorlastcharacterinnicknames.

• Nicknames are case-sensitive. For example, hp and HP are different nicknames.

1. Start LUN Manager. The LUN Manager pane (Figure 14)appears.

2. If the desired host has previously been connected via a cable to another port in the array, take the

following steps:

a. In the WWN name table, select the port to which the host is connected from the Port list.

b. In the WWN name table, select the host bus adapter. From the tree, select a host group, and

click Add WWN.

NOTE:

If you are using Windows, you can drag the host bus adapter from the WWN

name table to the host group in the tree. To drag two or more host bus

adapters, see the

HP StorageWorks Command View XP user guide for XP

Disk Arrays

or the

HP StorageWorks XP Remote Web Console user guide for

XP12000/XP10000/SVS200

for instructions.

Figure 39 Add New WWN dialog box (when registering a host that was

previously connected to the array)

c. To assign a nickname to the host bus adapter, enter the nickname in the Nickname box, and

click OK.

NOTE:

If you select two or more host bus adapters, Add New WWN dialog boxes (Figure 39)

appear one after another to let you assign a nickname to each selected HBA. If you do

not need to assign nicknames to HBAs, you can select The remaining WWNs do not

need names,andclickOK. If you select this option, the Add New WWN dialog box

(Figure 39) no longer appears to prompt you to assign nicknames.

3. If the desired host has nev

er been connected via a cable to any port in the array, take the following

steps:

a. In the tree, right-click the host group, and select Add New WWN. The Add New WWN pane

appears.

HP StorageWorks LUN Conﬁguration and Security Manager XP user guide for the

XP12000/XP10000/SVS200