SVS200 LUN Manager and Volume Manager (T1714-96015, October 2007)

Figure 48 Change Host Group dialog box (Option selected)

NOTE:

After you click Option, the pane expands to display a list of host mode options. The No.

column indicates option numbers. Select the check box for the option you want to specify.

5. Click OK. Changes are indicated in blue in the table.

6. Click Apply.Aconﬁrmation message appears.

7. Click OK. Changes to the host group name and host mode are applied to the array.

Changing an iSCSI target's name and host mode

NOTE:

You cannot perform this operation on iSCSI targets for initiator ports.

CAUTION:

Before changing an iSCSI target's host mode, HP recommends that you ﬁrst back up data on the port

the iSCSI target belongs to. The operation for setting the host mode should not be destructive, but data

integrity cannot be guaranteed without a backup.

1. Start LUN Manager. The LUN Manager pane (Figure 15) appears.

2. In the tree, right-click the iSCSI target, and select Change iSCSI Target. The Change iSCSI Target

pane appears.

94 LUN Manager operations